- Robot’s Battery LEDs are blinking in a special pattern (central LED – then right and left LEDs). The issue occurred while the robot was connected to the charger.
|
- In case the robot feels hot to the touch: charge the robot in a shaded location or when the temperature is low, for example: overnight / indoors.
- In case the robot feels cold to the touch: try charging the robot in a warmer location.
|
- The Power Unit doesn’t show any LEDs at all.
|
- Try connecting the charger to a different power outlet. Make sure that the charger LED is on.
|
- The Power Button LED is red.
|
- Try disconnecting the charger from the Power Unit and connecting it back a few times.
- Check whether an object is blocking the connection between the charger and the Power Unit.
|
- The charging process stops, and the Power Button LED is blinking red for a short period of time.
|
- Make sure that the charger is connected properly.
- Check whether an object is blocking the connection between the charger and the Power Unit.
|
- Charging progress is stuck: one of the battery LEDs is blinking and doesn’t switch to the steady light after a long period of time.
|
- Check that the charger LED turns on.
- Make sure that the charger is connected properly.
- Check whether an object is blocking the connection between the charger and the Power Unit.
- Charge overnight in a cooler location.
|
My Dolphin when plugged in to charge it goes to charged [red] then to fully charged [green] after ten minutes other times it goes to fault [yellow]
I have disconnected the battery and reconnected it many times and it works sometimes.
Issue Category:
Power and Charging
Ownership Length:
N/A