Pentair Mastertemp 125 Troubleshooting

I have problems with my Pentair Mastertemp 125

Most Common Pentair Mastertemp 125 Reported Problems

Technical Malfunctions
2 issues

Technical Malfunction Issues

Power and Charging Issues

Performance Issues

Setup and Usage Issues

Customer Support Issues

Other Issues

Pentair Mastertemp 125 Pool Heater Not Working?

If you're experiencing issues with your Pentair Mastertemp 125 pool equipment, you're not alone. Many users have faced similar challenges and have shared their experiences to help others troubleshoot and resolve these problems.

  1. Pentair Mastertemp 400HD: connected to a pool only, starts up just fine, runs for a few minutes sometimes to about 10 minutes to even 25 minutes then Heater shuts off, goes into spa on (No spa connected) and the control panel displays a temperature reading of 215 F then starts to decline. I have no error codes, or lights on the back of the control panel. If I turn the pool on again, same thing, it will run then shut off minutes later. I have replaced the Stack flue sensor, the Thermistor, Thermal regulator, High Limit Switch and the Automatic Gas Shut off. I used a meter to check the conductivity of all electrical connections, all good. Since it fires up, the control panel is working, heat is set to 84 and displays water temperature heating from 76-80, it runs for a few cycles so I am steering away from ignition issues and thinking Gas Valve. Any thoughts??

    Reply Submit Your Own Issue
  2. I have had error codes and had parts replaced. After turning on the heater, in the first 5 minutes or less it shuts off and says service heater. I have noticed since it was installed 2 years ago, it doesnt seem to have as much exhaust pressure coming out. There don’t seem to be anything blocking the exhaust either. Help anyone?

    Reply Submit Your Own Issue

Submit an Product Issue for Pentair Mastertemp 125

The maximum upload file size: 10 MB. You can upload: image. Links to YouTube, Facebook, Twitter and other services inserted in the comment text will be automatically embedded. Drop file here